- ページ 18

ストレージ Dell PowerVault DR4100のPDF ベスト・プラクティス・マニュアルをオンラインで閲覧またはダウンロードできます。Dell PowerVault DR4100 41 ページ。 Backup and recovery appliance
Dell PowerVault DR4100 にも: スタートマニュアル (10 ページ), マニュアル (37 ページ), リリースノート (16 ページ), マニュアル (12 ページ), マニュアル (24 ページ), マニュアル (23 ページ), クイックセットアップ (1 ページ), マニュアル (27 ページ), マニュアル (25 ページ)

Dell PowerVault DR4100 ベスト・プラクティス・マニュアル
Note: Always ensure that data source system (i.e. systems that send data to the DR4100) are located on the same
subnet. Failure to do so will result in all traffic being sent to the first interface in the bond. This is because adaptive load
balancing cannot properly load balance when data sources are located on a remote subnet. This is a result of ALB use
of (ARP) which is subnet-specific and a router's inability to send ARP broadcast and updates.
Figure 2
By default, the DR4100 sets up bonding on its fastest interfaces. If the appliance is configured with NIC combo 3 (see
Table 1) the 2x 10GB interfaces will become the new bond0. If the DR4100 is configured with combo 1, the 4x 1GB
interfaces will become bond0. As of firmware 2.1 the default bond behavior can be changed by utilizing the
auto_bonding_speed parameter. See below for usage example.
To reset the default bond run the command:
network --factory_reset [--auto_bonding_speed <1G|10G>]
After resetting the interface the DR4100 will prompt you to enter a reboot command.
Note: This command has to be issued from iDRAC, KVM or a local interface because it will disconnect any existing
network connections.
System –reboot
18
DR4100 Best Practice Guide | April 2014
Adaptive load balancing