Dell PowerVault DR4100 모범 사례 매뉴얼 - 페이지 18

{카테고리_이름} Dell PowerVault DR4100에 대한 모범 사례 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault DR4100 41 페이지. Backup and recovery appliance
Dell PowerVault DR4100에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (10 페이지), 매뉴얼 (37 페이지), 릴리스 노트 (16 페이지), 매뉴얼 (12 페이지), 매뉴얼 (24 페이지), 매뉴얼 (23 페이지), Qiuck 설정 (1 페이지), 매뉴얼 (27 페이지), 매뉴얼 (25 페이지)

페이지 인쇄

Note: Always ensure that data source system (i.e. systems that send data to the DR4100) are located on the same

subnet. Failure to do so will result in all traffic being sent to the first interface in the bond. This is because adaptive load

balancing cannot properly load balance when data sources are located on a remote subnet. This is a result of ALB use

of (ARP) which is subnet-specific and a router's inability to send ARP broadcast and updates.

Figure 2

By default, the DR4100 sets up bonding on its fastest interfaces. If the appliance is configured with NIC combo 3 (see

Table 1) the 2x 10GB interfaces will become the new bond0. If the DR4100 is configured with combo 1, the 4x 1GB

interfaces will become bond0. As of firmware 2.1 the default bond behavior can be changed by utilizing the

auto_bonding_speed parameter. See below for usage example.

To reset the default bond run the command:

network --factory_reset [--auto_bonding_speed <1G|10G>]

After resetting the interface the DR4100 will prompt you to enter a reboot command.

Note: This command has to be issued from iDRAC, KVM or a local interface because it will disconnect any existing

network connections.

System –reboot

DR4100 Best Practice Guide | April 2014

Adaptive load balancing