- ページ 9

ストレージ Dell PowerVault MD3000iのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Dell PowerVault MD3000i 46 ページ。 Configuration for vmware esx server software
Dell PowerVault MD3000i にも：チューニング・マニュアル (32 ページ), サポートノート (22 ページ), アップグレードマニュアル (28 ページ), 交換マニュアル (4 ページ), 設定マニュアル (10 ページ)

11 The installation is now complete. Click Done to close the installation

wizard.

NOTE:

To verify successful installation of the application server, run services.msc,

and verify that the cimserver service has been installed and has started along with

the Jetty6-Service service. Also note that after the application server has been

rebooted, the name of the CIMOM service will change to Pegasus CIM Object

Manager.

Application and vCenter Server Configuration

After the application server has been installed, verify the Dell Storage

vCenter Plug-In has been successfully registered with the vCenter server.

Open a vSphere Client to the vCenter Server, and select Plug-insManage

Plug-ins. You should see the Dell Storage vCenter Plug-In listed as enabled. If

it is listed as disabled with an error message stating that it cannot

communicate with the application server, verify that the port number defined

for the Jetty server is enabled to pass through any firewalls that may be in use.

The default Jetty TCP port number is 8084 and 8081.

After the application server and vCenter server have been configured, you

should now see the Dell Storage vCenter Plug-in icon on the home page of

the vSphere Client under the Solution and Application section as shown in

Figure 2.

Dell MD Storage Array vCenter Plug-in