Dell PowerVault MD3000i Посібник користувача - Сторінка 9

Переглянути онлайн або завантажити pdf Посібник користувача для Зберігання Dell PowerVault MD3000i. Dell PowerVault MD3000i 46 сторінок. Configuration for vmware esx server software
Також для Dell PowerVault MD3000i: Посібник з налаштування (32 сторінок), Примітка про підтримку (22 сторінок), Посібник з оновлення (28 сторінок), Посібник із заміни (4 сторінок), Посібник з конфігурації (10 сторінок)

11 The installation is now complete. Click Done to close the installation

wizard.

NOTE:

To verify successful installation of the application server, run services.msc,

and verify that the cimserver service has been installed and has started along with

the Jetty6-Service service. Also note that after the application server has been

rebooted, the name of the CIMOM service will change to Pegasus CIM Object

Manager.

Application and vCenter Server Configuration

After the application server has been installed, verify the Dell Storage

vCenter Plug-In has been successfully registered with the vCenter server.

Open a vSphere Client to the vCenter Server, and select Plug-insManage

Plug-ins. You should see the Dell Storage vCenter Plug-In listed as enabled. If

it is listed as disabled with an error message stating that it cannot

communicate with the application server, verify that the port number defined

for the Jetty server is enabled to pass through any firewalls that may be in use.

The default Jetty TCP port number is 8084 and 8081.

After the application server and vCenter server have been configured, you

should now see the Dell Storage vCenter Plug-in icon on the home page of

the vSphere Client under the Solution and Application section as shown in

Figure 2.

Dell MD Storage Array vCenter Plug-in