Dell PowerVault MD3000i Посібник користувача - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник користувача для Зберігання Dell PowerVault MD3000i. Dell PowerVault MD3000i 46 сторінок. Configuration for vmware esx server software
Також для Dell PowerVault MD3000i: Посібник з налаштування (32 сторінок), Примітка про підтримку (22 сторінок), Посібник з оновлення (28 сторінок), Посібник із заміни (4 сторінок), Посібник з конфігурації (10 сторінок)

Software Installation

Obtain the correct version of the Dell Storage vCenter Plug-in for your

environment (x86 or x64) from the Download and Drivers area at

support.dell.com. See the Support Matrix at support.dell.com/manuals for

the most current versions. The file should be copied to the application server.

NOTE:

It is highly recommended that the application server be installed on a

separate Windows 2003 or 2008 server from the existing VMware vCenter Server.

However, the application server may be installed on the same host as the existing

vCenter Server if adequate resources are available on the vCenter Server.

After the Dell Storage vCenter Plug-in software has been downloaded, run

the package on the application server to launch the installation wizard. The

installation wizard will install a Jetty application server, SMI-S provider, and

equipment in the environment, such as IP addresses and DNS names, must

be supplied during the installation process. The above table may be used to

help facilitate recording this information for the installation. Follow the

procedure below to install the software:

1 Read the introduction screen, and click Next.

2 Read through the license agreement and if you accept the terms, select the

appropriate option, and click Next.

3 Either select the local installation directory for the plug-in manager, or

click Next for the default.

4 Review the installation details, and click Install if the details are correct.

5 Change the port number of the Jetty server if you wish to, or accept the

default of 8084 and 8081, and click Next.

6 Change the IP address of the application server if desired. The IP address

will default to the IP address of the system the installer is running on.

Click Next.

7 The next screen prompts you for the IP address of the vCenter server that

the plug-in will be installed on. Enter the IP address of the vCenter server,

and click Next.

8 Enter the Administrator's email address for alerts, and click Next.

9 Enter the vCenter Administrator's User ID, and click Next.

10 Enter the vCenter Administrator's password, and click Next.

Dell MD Storage Array vCenter Plug-in