- ページ 3
ストレージ Dell PowerVault MD3600i SeriesのPDF サポート・マトリックスをオンラインで閲覧またはダウンロードできます。Dell PowerVault MD3600i Series 11 ページ。 Storage arrays
Dell PowerVault MD3600i Series にも： サポート・マトリックス (12 ページ), インストレーション・マニュアル (18 ページ), サポート・マトリックス (17 ページ)
ページを印刷する
be run in unified mode.
A hot spare for a disk group
must be a physical disk of
equal or greater size than
any of the member disks.
When using out-of-band
management with SMcli by
specifying the RAID
Controller management port
IP addresses on the MD
Storage Array, SMcli
commands that change the
attributes of a virtual disk,
virtual disk copy, or snapshot
virtual disk, must have
management access to the
owning RAID Controller
Module to complete. Where
applicable it is a best practice
to specify both management
port IP addresses on the
SMcli invocation: "SMcli
192.168.128.101
192.168.128.102 -c".
Co-existence of multiple
Linux multi-pathing drivers is
not supported. When using a
MD3200 Series or MD3600
Series array with Linux host
servers only the Linux
Device Mapper failover driver
is supported.
**
On Linux systems Device
Mapper multi-pathing drivers
are required for multi-path
support
Virtual disks on an MD3200
Series or MD3600 Series
cannot be used for booting.
RAID 5 and RAID 6 disk
groups are limited to a
maximum of 30 physical
disks
Disk Groups can be migrated
between a Dell PowerVault
MD3200 or MD3200i or
MD3600i by following the
appropriate Disk Group
migration procedure***
All iSCSI Host ports on a
controller have to be at the
same port speed
iSCSI Host ports will only
auto-negotiate to the port
speed set in MDSM
Only single path iSCSI boot
is supported for all Linux
OS's. Multi-path iSCSI boot
on Linux is not supported.
√
√
√
√
√
√
√
Not Applicable for SAS
Not Applicable for SAS
Not Applicable for SAS
√
√
√
√
√
√
√
Only 1Gbps Supported
Only 1Gbps Supported
√
√
√
√
√
√
√
√
√
√
√