Dell PowerVault MD3600i Series Матриця підтримки - Сторінка 3
Переглянути онлайн або завантажити pdf Матриця підтримки для Зберігання Dell PowerVault MD3600i Series. Dell PowerVault MD3600i Series 11 сторінок. Storage arrays
Також для Dell PowerVault MD3600i Series: Матриця підтримки (12 сторінок), Посібник з монтажу (18 сторінок), Матриця підтримки (17 сторінок)
Друкувати сторінку
be run in unified mode.
A hot spare for a disk group
must be a physical disk of
equal or greater size than
any of the member disks.
When using out-of-band
management with SMcli by
specifying the RAID
Controller management port
IP addresses on the MD
Storage Array, SMcli
commands that change the
attributes of a virtual disk,
virtual disk copy, or snapshot
virtual disk, must have
management access to the
owning RAID Controller
Module to complete. Where
applicable it is a best practice
to specify both management
port IP addresses on the
SMcli invocation: "SMcli
192.168.128.101
192.168.128.102 -c".
Co-existence of multiple
Linux multi-pathing drivers is
not supported. When using a
MD3200 Series or MD3600
Series array with Linux host
servers only the Linux
Device Mapper failover driver
is supported.
**
On Linux systems Device
Mapper multi-pathing drivers
are required for multi-path
support
Virtual disks on an MD3200
Series or MD3600 Series
cannot be used for booting.
RAID 5 and RAID 6 disk
groups are limited to a
maximum of 30 physical
disks
Disk Groups can be migrated
between a Dell PowerVault
MD3200 or MD3200i or
MD3600i by following the
appropriate Disk Group
migration procedure***
All iSCSI Host ports on a
controller have to be at the
same port speed
iSCSI Host ports will only
auto-negotiate to the port
speed set in MDSM
Only single path iSCSI boot
is supported for all Linux
OS's. Multi-path iSCSI boot
on Linux is not supported.
√
√
√
√
√
√
√
Not Applicable for SAS
Not Applicable for SAS
Not Applicable for SAS
√
√
√
√
√
√
√
Only 1Gbps Supported
Only 1Gbps Supported
√
√
√
√
√
√
√
√
√
√
√