- ページ 33

ストレージ Dell PowerVault NX1950のPDF 設置およびトラブルシューティング・マニュアルをオンラインで閲覧またはダウンロードできます。Dell PowerVault NX1950 48 ページ。 For vmware esx server software
Dell PowerVault NX1950 にも：配備マニュアル (34 ページ), 重要事項説明書 (26 ページ), はじめに (49 ページ), 配備マニュアル (38 ページ), アップグレードマニュアル (18 ページ), リファレンス・マニュアル (4 ページ), セッティング (2 ページ), 使用 (2 ページ), 設定マニュアル (11 ページ)

To remove the cluster node using the cluster.exe tool, you must stop the cluster

service and then evict the node by performing the following procedure:

1 Open an MS-DOS

2 Enter the following commands:

cluster node <node name> /stop

cluster node <node name> /evict

3 After executing these commands, enter the following command to ensure

that the node has been removed:

cluster node <node name> /status

It is recommended that you verify that the node has been removed by

checking from another node in the cluster.

Removing the Last Node

Removing the last node in the cluster is different than removing other nodes

in the cluster. Removing the last node removes the cluster.

To remove the last node using Cluster Administrator, stop the Cluster Service

on the node, and then click File

To remove the last node, using the cluster.exe tool, enter the following

commands:

cluster node <node name> /stop

cluster node <node name> /forcecleanup

NOTICE:

If this operation fails, the PowerVault NX1950 cluster solution does not

function properly. Exercise extreme caution in planning the cluster so that removal

of the last node is not necessary.

To replace a node, you must remove the node and then add a node manually.

For instructions about removing a node, see "Removing Nodes From the

Cluster" on page 32. For instructions about adding a node manually, see

"Adding a Node Manually" on page 29.

prompt.

→

Evict Node.

Managing Your Cluster