Dell PowerVault NX1950 설치 및 문제 해결 매뉴얼 - 페이지 33

{카테고리_이름} Dell PowerVault NX1950에 대한 설치 및 문제 해결 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault NX1950 48 페이지. For vmware esx server software
Dell PowerVault NX1950에 대해서도 마찬가지입니다: 배포 매뉴얼 (34 페이지), 중요 정보 매뉴얼 (26 페이지), 시작하기 (49 페이지), 배포 매뉴얼 (38 페이지), 업그레이드 매뉴얼 (18 페이지), 참조 매뉴얼 (4 페이지), 설정 (2 페이지), 사용 (2 페이지), 구성 매뉴얼 (11 페이지)

페이지 인쇄
Dell PowerVault NX1950 설치 및 문제 해결 매뉴얼
To remove the cluster node using the cluster.exe tool, you must stop the cluster
service and then evict the node by performing the following procedure:
1 Open an MS-DOS
2 Enter the following commands:
cluster node <node name> /stop
cluster node <node name> /evict
3 After executing these commands, enter the following command to ensure
that the node has been removed:
cluster node <node name> /status
It is recommended that you verify that the node has been removed by
checking from another node in the cluster.

Removing the Last Node

Removing the last node in the cluster is different than removing other nodes
in the cluster. Removing the last node removes the cluster.
To remove the last node using Cluster Administrator, stop the Cluster Service
on the node, and then click File
To remove the last node, using the cluster.exe tool, enter the following
commands:
cluster node <node name> /stop
cluster node <node name> /forcecleanup
NOTICE:
If this operation fails, the PowerVault NX1950 cluster solution does not
function properly. Exercise extreme caution in planning the cluster so that removal
of the last node is not necessary.

Replacing a Node

To replace a node, you must remove the node and then add a node manually.
For instructions about removing a node, see "Removing Nodes From the
Cluster" on page 32. For instructions about adding a node manually, see
"Adding a Node Manually" on page 29.
®
prompt.
→
Evict Node.
Managing Your Cluster
33