- ページ 15

スイッチ Dell EMC Edge 510 LTEのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Dell EMC Edge 510 LTE 24 ページ。 Networking switch
Dell EMC Edge 510 LTE にも：セットアップマニュアル (8 ページ)

ページを印刷する

1. Sim Card

● Place unit near a properly grounded AC power outlet

● In a temperature-controlled room with a temperature range from 0°C to 40°C (32°F to 104°F)

● In a dry, clean, and well-ventilated room away from heat sources such as hot air vents or direct sunlight

● Away from severe electromagnetic noise

The numbers one through four in the following figure correspond to the setup procedure:

1. Connect the DC power connector on the power adapter to the power port on the Dell EMC Edge 510 LTE and secure it by

turning the lock-screw. Connect the AC power cable to the power adapter and plug the other end of AC power cable into

AC power outlet.

NOTE:

Connect the power adapter to a properly wired earth-ground AC power outlet.

2. Attach either the GE3 or GE4 1 Gb WAN Ethernet port to an available Internet connection.

NOTE:

Use ONLY the GE3 or GE4 1 Gb WAN Ethernet ports for Internet connection.

● GE3, GE4 1 Gb WAN Ethernet ports

NOTE:

By default, the Edge gets a DHCP IP address from the ISP on the WAN uplink. When the WAN connection is

fully operational, the service indicator LED on the front of the Edge 510 LTE is green.

Edge 510 LTE installation