Dell EMC Edge 510 LTE Installatiehandleiding - Pagina 15
Blader online of download pdf Installatiehandleiding voor {categorie_naam} Dell EMC Edge 510 LTE. Dell EMC Edge 510 LTE 24 pagina's. Networking switch
Ook voor Dell EMC Edge 510 LTE: Installatiehandleiding (8 pagina's)
Pagina afdrukken
● Place unit near a properly grounded AC power outlet
● In a temperature-controlled room with a temperature range from 0°C to 40°C (32°F to 104°F)
● In a dry, clean, and well-ventilated room away from heat sources such as hot air vents or direct sunlight
● Away from severe electromagnetic noise
The numbers one through four in the following figure correspond to the setup procedure:
1. Connect the DC power connector on the power adapter to the power port on the Dell EMC Edge 510 LTE and secure it by
turning the lock-screw. Connect the AC power cable to the power adapter and plug the other end of AC power cable into
AC power outlet.
NOTE:
Connect the power adapter to a properly wired earth-ground AC power outlet.
2. Attach either the GE3 or GE4 1 Gb WAN Ethernet port to an available Internet connection.
NOTE:
Use ONLY the GE3 or GE4 1 Gb WAN Ethernet ports for Internet connection.
● GE3, GE4 1 Gb WAN Ethernet ports
NOTE:
By default, the Edge gets a DHCP IP address from the ISP on the WAN uplink. When the WAN connection is
fully operational, the service indicator LED on the front of the Edge 510 LTE is green.
Edge 510 LTE installation
15