- ページ 25

スイッチ Dell EMC PowerSwitch S6100-ONのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Dell EMC PowerSwitch S6100-ON 48 ページ。

I/O module installation

NOTE:

Install a blank panel in any unused switch I/O slot.

NOTE:

The S6100-ON has capacitors on the front-left corner of the PC board. To avoid damaging these capacitors, align

the I/O module with the yellow arrows located inside the chassis and then gently slide the I/O module in place.

1. Remove the I/O module from the electro-static bag.

2. Open the left ejector lever, item 1, by pressing in the orange tab, item 2, and rotating it to the right.

The level snaps into the open position.

3. Slide the I/O module into the switch I/O slot.

The slot is keyed so that the I/O module fully inserts in only one way. When you install the I/O module correctly, it snaps into

place and is flush with the back of the switch.

Figure 20. I/O module installation

a. Ejector lever

b. Orange release tab

c. I/O module

The S6100–ON is designed to support two hot-swappable power supplies with integrated fans that provide cooling for the

chassis.

● The S6100–ON ships with two power supplies.

● The PSU slides into the slot smoothly. Do not force the PSU into a slot as this action may damage the PSU or the S6100-ON

chassis.

S6100–ON installation