Dell EMC PowerSwitch S6100-ON Manuel d'installation - Page 25
Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Dell EMC PowerSwitch S6100-ON. Dell EMC PowerSwitch S6100-ON 48 pages.
Imprimer la page
I/O module installation
NOTE:
Install a blank panel in any unused switch I/O slot.
NOTE:
The S6100-ON has capacitors on the front-left corner of the PC board. To avoid damaging these capacitors, align
the I/O module with the yellow arrows located inside the chassis and then gently slide the I/O module in place.
1. Remove the I/O module from the electro-static bag.
2. Open the left ejector lever, item 1, by pressing in the orange tab, item 2, and rotating it to the right.
The level snaps into the open position.
3. Slide the I/O module into the switch I/O slot.
The slot is keyed so that the I/O module fully inserts in only one way. When you install the I/O module correctly, it snaps into
place and is flush with the back of the switch.
Figure 20. I/O module installation
a. Ejector lever
b. Orange release tab
c. I/O module
Important points
The S6100–ON is designed to support two hot-swappable power supplies with integrated fans that provide cooling for the
chassis.
● The S6100–ON ships with two power supplies.
● The PSU slides into the slot smoothly. Do not force the PSU into a slot as this action may damage the PSU or the S6100-ON
chassis.
S6100–ON installation
25