- ページ 16

スイッチ Dell Force10 C150のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Dell Force10 C150 33 ページ。 Quick start guide

Installing RPMs and Line Cards

WARNING: Always wear an ESD-preventive wrist or foot-heel ground strap

when handling RPMs or line cards. Place RPMs and line cards on an antistatic

surface when they are not installed. Electrostatic discharge (ESD) damage can

occur when components are mishandled.

CAUTION: Unlock the levers before inserting the line card into the chassis.

Fully engage the locking mechanism after the card has been inserted; not

doing so might damage the card below it when that lower card is inserted.

NOTE: The fan tray face panel has slot number markings for the RPMs and line

cards. Insert the fan tray before the line cards to simplify RPM and line card

installation.

Step

Task

Extend the left and right card levers by first pressing gently down on the

thumb tabs in the ejector levers and then pulling the ejector levers

simultaneously until they are in the open position.

Hold the card assembly by the metal carrier edges. Avoid touching the

printed circuit board and connector pins.

Align the card with the guide, and gently slide it into any line card slot

until the card is about halfway into the slot.

Continue sliding the card until you feel the connectors engage with the

chassis backplane.

Rotate the levers toward the card to seat the backplane connectors and

line card in place. Push on the knurled section of the levers until the

thumb tabs pop up and lock the unit in place.

Install a blank panel in all slots that do not have a card, and secure it

with the screws provided.

Installing the Hardware

NOTE: Use the markings on the fan tray to determine which slots

are for the RPMs and which are for the line cards.

CAUTION: Installing a card without fully engaging the

locking mechanism might damage the EMI seal on the card

below it when that card is inserted.