- ページ 20

スイッチ Dell Force10 S25 SeriesのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Dell Force10 S25 Series 27 ページ。 Basic layer 2 setup and buffer tuning of the s25p for storage environments
Dell Force10 S25 Series にも：設定マニュアル (8 ページ)

ページを印刷する

Default Configuration

A version of the Dell Force10 Operating System (FTOS) is pre-loaded onto the

chassis, however the system is not configured when you power up for the first

time (except for the default hostname, which is Force10). You must configure

the system using the Command Line Interface (CLI).

Configure Layer 2 (Data Link) Mode

Use the switchport command in INTERFACE mode to enable Layer 2 data

transmissions through an individual interface. The user cannot configure

switching or Layer 2 protocols such as spanning tree protocol on an interface

unless the interface has been set to Layer 2 mode.

Step Task

Enable the interface.

Place the interface in

Layer 2 (switching)

mode.

To view the interfaces in Layer 2 mode, use the show interfaces switchport

command in the EXEC mode.

Configure a Host Name

The host name appears in the prompt. The default host name is Force10.

•

Host names must start with a letter and end with a letter or digit.

•

Characters within the string can be letters, digits, and hyphens.

Task

Create a new host name.

Access the System Remotely

You can configure the system to be accessed remotely by Telnet.

Installing the Software

Command Syntax

no shutdown

switchport

Command Syntax

hostname name

Command Mode

INTERFACE

Command Mode

CONFIGURATION