- ページ 19

スイッチ Dell Force10 S25 SeriesのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Dell Force10 S25 Series 27 ページ。 Basic layer 2 setup and buffer tuning of the s25p for storage environments
Dell Force10 S25 Series にも：設定マニュアル (8 ページ)

ページを印刷する

Step

Task

Set your initial console terminal settings to match the default console settings on

the switch.

9600 baud rate

No parity

8 data bits

1 stop bit

No flow control (console port only)

After establishing a connection, you can modify the settings to match at each

end of the connection.

S25P only: If you use the console port to download software to the switch, you

will probably want to raise the console baud rate. Establish a connection with

the default settings to verify the connection. Then use the lineconfig command

to access the Line Config mode, and use the serial baudrate command to raise

the baud rate on the console port. (Match the settings in your terminal access

program.)

Accessing the Console Port

Connect the RJ-45/DB-9 adapter that is shipped with the S25P system to the RJ-

45 cable.

Table 2-1. Pin Assignments for Console Port

Signal

RJ-45 Pinout

RXD

GND

TXD

Installing the Software