Dell Force10 S25 Series 빠른 시작 매뉴얼 - 페이지 19
{카테고리_이름} Dell Force10 S25 Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Force10 S25 Series 27 페이지. Basic layer 2 setup and buffer tuning of the s25p for storage environments
Dell Force10 S25 Series에 대해서도 마찬가지입니다: 구성 매뉴얼 (8 페이지)
페이지 인쇄
Step
Task
Set your initial console terminal settings to match the default console settings on
3
the switch.
9600 baud rate
No parity
8 data bits
1 stop bit
No flow control (console port only)
After establishing a connection, you can modify the settings to match at each
end of the connection.
S25P only: If you use the console port to download software to the switch, you
4
will probably want to raise the console baud rate. Establish a connection with
the default settings to verify the connection. Then use the lineconfig command
to access the Line Config mode, and use the serial baudrate command to raise
the baud rate on the console port. (Match the settings in your terminal access
program.)
Accessing the Console Port
Connect the RJ-45/DB-9 adapter that is shipped with the S25P system to the RJ-
45 cable.
Table 2-1. Pin Assignments for Console Port
Signal
RJ-45 Pinout
NC
NC
RXD
GND
GND
TXD
NC
NC
1
2
3
4
5
6
7
8
Installing the Software
17