- ページ 22

スイッチ Dell Force10 S4820T SystemのPDF スタートマニュアルをオンラインで閲覧またはダウンロードできます。Dell Force10 S4820T System 39 ページ。

Two-post Flush-mount Configuration:

1 For this configuration, you must remove the castings from the front side of

each ReadyRails assembly. Refer to Figure 1-6, item 1. Use a Torx driver to

remove the two screws from each front flange ear (on the switch side of the

rail) and remove each casting. Retain the castings for future rack

requirements. It is not necessary to remove the rear flange castings.

Figure 1-6. Two-post Flush-mount Configuration

2 Attach one rail to the front post flange with two user-supplied screws.

Refer to Figure 1-6, item 2.

3 Slide the plunger bracket forward against the vertical post and secure the

plunger bracket to the post flange with two user-supplied screws. Refer

to Figure 1-6, item 3.

Installation