- ページ 34
スイッチ Dell Force10 S4820T SystemのPDF スタートマニュアルをオンラインで閲覧またはダウンロードできます。Dell Force10 S4820T System 39 ページ。
ページを印刷する
Access the System Remotely
You can configure the S4820T system to be accessed remotely by Telnet. The
system has a dedicated management port and a management routing table that is
separate from the IP routing table.
To access the system remotely, follow these steps:
Step
Task
Configure an IP address for the management port
1
Port IP
Address).
Configure a management route with a default gateway
2
Management
Configure a username and password
3
Configure the Management Port IP Address
In order to access the system remotely, assign IP addresses to the management
ports.
To assign IP addresses to the management ports, follow these steps:
Step Task
Enter INTERFACE
1
mode for the
Management port.
Assign an IP address
2
to the interface.
Enable the interface.
3
28
Performing the Initial Configuration
Route).
Command Syntax
interface ManagementEthernet
slot/port
ip address ip-address/mask
no shutdown
(Configure the Management
(Configure the
(Configure the Username and
Password).
Command Mode
CONFIGURATION
INTERFACE
INTERFACE