Dell Force10 S4820T System 시작하기 매뉴얼 - 페이지 34
{카테고리_이름} Dell Force10 S4820T System에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Force10 S4820T System 39 페이지.
페이지 인쇄
Access the System Remotely
You can configure the S4820T system to be accessed remotely by Telnet. The
system has a dedicated management port and a management routing table that is
separate from the IP routing table.
To access the system remotely, follow these steps:
Step
Task
Configure an IP address for the management port
1
Port IP
Address).
Configure a management route with a default gateway
2
Management
Configure a username and password
3
Configure the Management Port IP Address
In order to access the system remotely, assign IP addresses to the management
ports.
To assign IP addresses to the management ports, follow these steps:
Step Task
Enter INTERFACE
1
mode for the
Management port.
Assign an IP address
2
to the interface.
Enable the interface.
3
28
Performing the Initial Configuration
Route).
Command Syntax
interface ManagementEthernet
slot/port
ip address ip-address/mask
no shutdown
(Configure the Management
(Configure the
(Configure the Username and
Password).
Command Mode
CONFIGURATION
INTERFACE
INTERFACE