Dell Force10 S4820T System 시작하기 매뉴얼 - 페이지 38

{카테고리_이름} Dell Force10 S4820T System에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Force10 S4820T System 39 페이지.

Assign an IP Address to a VLAN

VLANs are a Layer 2 feature. For two physical interfaces on different VLANs

to communicate, you must assign an IP address to the VLANs to route traffic

between the two interfaces. The shutdown command in INTERFACE mode

does not affect Layer 2 traffic on the interface.

NOTE: You cannot assign an IP address to the Default VLAN, which, by default,

is VLAN 1. To assign another VLAN ID to the Default VLAN, use the default

vlan-id vlan-id command.

To assign an IP address to a VLAN, follow this step:

Task

Configure an IP address

and mask on the interface.

After you have completed the hardware installation and software configuration

for the S4820T system, you can connect to your company network by following

your company's cabling requirements.

Performing the Initial Configuration

Command Syntax

ip address ip-address mask

[secondary]

Command Mode

INTERFACE