Dell Force10 S4820T System Aan de slag handleiding - Pagina 38

Blader online of download pdf Aan de slag handleiding voor {categorie_naam} Dell Force10 S4820T System. Dell Force10 S4820T System 39 pagina's.

Assign an IP Address to a VLAN

VLANs are a Layer 2 feature. For two physical interfaces on different VLANs

to communicate, you must assign an IP address to the VLANs to route traffic

between the two interfaces. The shutdown command in INTERFACE mode

does not affect Layer 2 traffic on the interface.

NOTE: You cannot assign an IP address to the Default VLAN, which, by default,

is VLAN 1. To assign another VLAN ID to the Default VLAN, use the default

vlan-id vlan-id command.

To assign an IP address to a VLAN, follow this step:

Task

Configure an IP address

and mask on the interface.

After you have completed the hardware installation and software configuration

for the S4820T system, you can connect to your company network by following

your company's cabling requirements.

Performing the Initial Configuration

Command Syntax

ip address ip-address mask

[secondary]

Command Mode

INTERFACE