Dell Force10 S4820T System 시작하기 매뉴얼 - 페이지 37

{카테고리_이름} Dell Force10 S4820T System에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Force10 S4820T System 39 페이지.

To view which interfaces are tagged or untagged and to view which VLAN the

interfaces belong, use the show vlan command. To view just the interfaces that

are in Layer 2 mode, use the show interfaces switchport command in EXEC

Privilege mode or EXEC mode.

To tag frames leaving an interface in Layer 2 mode, you must assign that

interface to a port-based VLAN to tag it with that VLAN ID.

To tag interfaces, follow these steps:

Step Task

Access the

INTERFACE VLAN

mode of the VLAN to

which you want to

assign the interface.

Enable an interface to

include the IEEE

802.1Q tag header.

Use the untagged command to move untagged interfaces from the Default

VLAN to another VLAN:

To move untagged interfaces, follow these steps:

Step Task

Access the

INTERFACE VLAN

mode of the VLAN to

which you want to

assign the interface.

Configure an interface

as untagged. This

command is available

only in VLAN

interfaces.

Command Syntax

interface vlan vlan-id

tagged interface

Command Syntax

interface vlan vlan-id

untagged interface

Performing the Initial Configuration

Command Mode

CONFIGURATION

INTERFACE

Command Mode

CONFIGURATION

INTERFACE