Dell Force10 S4820T System 시작하기 매뉴얼 - 페이지 36

{카테고리_이름} Dell Force10 S4820T System에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Force10 S4820T System 39 페이지.

To configure the enable secret password, follow this step:

Task

Create a password to

access EXEC

Privilege mode.

Create a Port-based VLAN

The Default VLAN (VLAN 1) is part of the system startup configuration and

does not require configuration. To configure a port-based VLAN, you must

create the VLAN and then add physical interfaces or port channel (LAG)

interfaces to the VLAN.

To create a port-based VLAN, follow this step:

Task

Configure a port-based VLAN (if the

vlan-id is different from the Default

VLAN ID) and enter INTERFACE

VLAN mode. After you create a

VLAN, you must assign interfaces in

Layer 2 mode to the VLAN to activate

the VLAN.

To view the configured VLANs, use the show vlan command in EXEC

Privilege mode.

You can only assign interfaces in Layer 2 mode to a VLAN using the tagged and

untagged commands. To place an interface in Layer 2 mode, use the switchport

command.

You can designate Layer 2 interfaces as tagged or untagged. When you place an

interface in Layer 2 mode using the switchport command, the interface is

automatically designated untagged and placed in the Default VLAN.

Performing the Initial Configuration

Command Syntax

enable [password | secret] [level level]

[encryption-type] password

Command Syntax

interface vlan vlan-id

Command Mode

CONFIGURATION

Command Mode

CONFIGURATION