Dell Force10 S4820T System Podręcznik dla początkujących - Strona 36

Przeglądaj online lub pobierz pdf Podręcznik dla początkujących dla Przełącznik Dell Force10 S4820T System. Dell Force10 S4820T System 39 stron.

To configure the enable secret password, follow this step:

Task

Create a password to

access EXEC

Privilege mode.

Create a Port-based VLAN

The Default VLAN (VLAN 1) is part of the system startup configuration and

does not require configuration. To configure a port-based VLAN, you must

create the VLAN and then add physical interfaces or port channel (LAG)

interfaces to the VLAN.

To create a port-based VLAN, follow this step:

Task

Configure a port-based VLAN (if the

vlan-id is different from the Default

VLAN ID) and enter INTERFACE

VLAN mode. After you create a

VLAN, you must assign interfaces in

Layer 2 mode to the VLAN to activate

the VLAN.

To view the configured VLANs, use the show vlan command in EXEC

Privilege mode.

You can only assign interfaces in Layer 2 mode to a VLAN using the tagged and

untagged commands. To place an interface in Layer 2 mode, use the switchport

command.

You can designate Layer 2 interfaces as tagged or untagged. When you place an

interface in Layer 2 mode using the switchport command, the interface is

automatically designated untagged and placed in the Default VLAN.

Performing the Initial Configuration

Command Syntax

enable [password | secret] [level level]

[encryption-type] password

Command Syntax

interface vlan vlan-id

Command Mode

CONFIGURATION

Command Mode

CONFIGURATION