- ページ 16

スイッチ Dell N2000 SeriesのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Dell N2000 Series 17 ページ。 Switch dell networking n2000 series
Dell N2000 Series にも： ファームウェアのアップグレード (21 ページ)

ページを印刷する
Dell N2000 Series マニュアル
3.5

Configure Jumbo MTU for all ports

Note: If iSCSI optimization is enabled, flow control is automatically configured on all switch ports upon
detection of an EqualLogic Array. Dell recommends also manually configuring this step.
console(config)#system jumbo mtu 9216
console(config)# exit
3.6

Configure spanning tree portfast on edge ports

Note: If iSCSI optimization is enabled, spanning tree portfast is automatically configured on ports
connected to EqualLogic arrays. These manual steps must be performed on switch ports connected to
hosts servers.
console#configure
console(config)#interface range gigabitethernet all
console(config-if)#spanning-tree portfast
console(config-if)#exit
3.7

Save configuration

console#copy running-config startup-config
This operation may take a few minutes.
Management interfaces will not be available during this time.
Are you sure you want to save? (y/n)y
Note: The preceding procedure places all switch ports in the default VLAN. If you prefer to place ports in
a non-default VLAN, refer to the documentation for your switch.
16
SCG1015
Dell Networking N2000 Series Configuration Guide