Dell N2000 Series Handmatig - Pagina 16

Blader online of download pdf Handmatig voor {categorie_naam} Dell N2000 Series. Dell N2000 Series 17 pagina's. Switch dell networking n2000 series
Ook voor Dell N2000 Series: Firmware-upgrade (21 pagina's)

Pagina afdrukken
Dell N2000 Series Handmatig
3.5

Configure Jumbo MTU for all ports

Note: If iSCSI optimization is enabled, flow control is automatically configured on all switch ports upon
detection of an EqualLogic Array. Dell recommends also manually configuring this step.
console(config)#system jumbo mtu 9216
console(config)# exit
3.6

Configure spanning tree portfast on edge ports

Note: If iSCSI optimization is enabled, spanning tree portfast is automatically configured on ports
connected to EqualLogic arrays. These manual steps must be performed on switch ports connected to
hosts servers.
console#configure
console(config)#interface range gigabitethernet all
console(config-if)#spanning-tree portfast
console(config-if)#exit
3.7

Save configuration

console#copy running-config startup-config
This operation may take a few minutes.
Management interfaces will not be available during this time.
Are you sure you want to save? (y/n)y
Note: The preceding procedure places all switch ports in the default VLAN. If you prefer to place ports in
a non-default VLAN, refer to the documentation for your switch.
16
SCG1015
Dell Networking N2000 Series Configuration Guide