- ページ 15
スイッチ Dell PowerConnect 5548のPDF スタートマニュアルをオンラインで閲覧またはダウンロードできます。Dell PowerConnect 5548 20 ページ。 Powerconnect 5500 series
Dell PowerConnect 5548 にも： リリースノート (15 ページ)
ページを印刷する
Booting the Switch
After the local terminal is connected, turn on power. The switch then goes
through power-on self-test (POST). POST runs every time the switch is
started and checks hardware components, to determine if the switch is
operational before completely booting. If the system detects a critical
problem, the boot process stops. If POST passes successfully, a valid
executable image is loaded into RAM. POST messages are displayed on the
terminal and indicate test success or failure.
The boot process runs for approximately 40-45seconds.
When the boot process completes, the following LEDs are lit, as shown in
Figure 3-2:
•
Power
•
Status
•
Fan (should be green)
•
RPS (if it is being used)
Figure 3-2. Initial LEDs
Power Status
Configuring the Switch
Fan
RPS
15