- ページ 9

スイッチ Dell PowerConnect 8024FのPDF 設定マニュアルをオンラインで閲覧またはダウンロードできます。Dell PowerConnect 8024F 21 ページ。 Upgrading from version 2.x.x.x or 3.x.x.x or 4.x.x.x or 5.x.x.x to 5.1.9.3 firmware
Dell PowerConnect 8024F にも：リリースノート (27 ページ), リリースノート (20 ページ), 実施マニュアル (8 ページ), ファームウェアのアップグレード (24 ページ)

ページを印刷する

2.11

Configure port channel for LAG

These commands configure the switch interconnect as a LAG.

console(conf)#interface Port-channel 1

console(conf-if-Po1)#mtu 9216

console(conf-if-Po1)#exit

2.12

Configure SFP+ ports for LAG

These commands assign four 10Gb SFP+ ports to the Port Channel.

console(conf)#interface range Tengigabitethernet 1/0/21-24

console(conf-if)#channel-group 1 mode active

console(conf-if)#exit

console(conf)#exit

2.13

Save configuration

console#copy running-config startup-config

This operation may take a few minutes.

Management interfaces will not be available during this time.

Are you sure you want to save? (y/n)y

2.14

Configure additional switch

Repeat the commands from section 2 to configure the second switch.

Note: The preceding procedure places all switch ports in the default VLAN. If you prefer to place ports in a

non-default VLAN, refer to the documentation for your switch.

SCG1008

PowerConnect 8024, 8024F, M8024 and M8024-k Switch Configuration Guide for EqualLogic SANs