- ページ 5

ネットワークカード Allied Telesis AT-AR027 VoIP-FXSのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Allied Telesis AT-AR027 VoIP-FXS 13 ページ。 Port interface card
Allied Telesis AT-AR027 VoIP-FXS にも: インストレーション・マニュアル (13 ページ), データシート (1 ページ), データシート (1 ページ), クイック・インストール・マニュアル (10 ページ), 設置および安全マニュアル (8 ページ)

Allied Telesis AT-AR027 VoIP-FXS インストレーション・マニュアル
4

Package Contents

The following items are included with each Port Interface Card (PIC). Contact your
authorised Allied Telesis distributor or reseller if any items are damaged or missing.
two spring-loaded retaining thumbscrews
two jumpers (AT-AR020 PRI E1/TI and AT-AR021(S) BRI-S/T only).
this Installation and Safety Guide
one warranty card
Choosing a PIC Bay
Observe the following guidelines when selecting a PIC bay:
Use the PIC bays on the switch or router base unit first, before installing PICs
into an AT-AR040 NSM.
Fill the PIC bays in an AT-AR040 NSM starting at bay 0.
You can install a maximum of two AT-AR020 PRI E1/T1 PICs into an AT-AR040
NSM, and maximum of four total in a switch or router.
If two AT-AR020 PICs are installed in an AT-AR040 NSM, PIC one must be
installed in the lower row (bay 0 or 1) and the other PIC must be installed in the
upper row (bay 2 or 3).
If an AT-AR020 PIC is installed in an AT-AR040 NSM, and operating in E1 mode,
you can not install an AT-AR021(S) or AT-AR021(U) PIC in the same row of the
NSM.
You can install a maximum of four AT-AR027 PICs in an AR745 router fitted with
an AT-AR040 NSM.
Avoid installing an AT-AR022 or AT-AR026 PIC in an AT-AR040 NSM.
Performance of these interfaces may be reduced and packet loss may occur.
For instructions on installing an AT-AR040 NSM into your switch or router, see the
Network Service Module Installation and Safety Guide supplied with the NSM. You can
also download this document from www.alliedtelesis.com/support/software.
Port Interface Card