- ページ 9

スイッチ Dell PowerConnect M8024-kのPDF 設定マニュアルをオンラインで閲覧またはダウンロードできます。Dell PowerConnect M8024-k 21 ページ。 Upgrading from version 2.x.x.x or 3.x.x.x or 4.x.x.x or 5.x.x.x to 5.1.9.3 firmware
Dell PowerConnect M8024-k にも：リリースノート (27 ページ), ファームウェアのアップグレード (24 ページ)

ページを印刷する

2.11

Configure port channel for LAG

These commands configure the switch interconnect as a LAG.

console(conf)#interface Port-channel 1

console(conf-if-Po1)#mtu 9216

console(conf-if-Po1)#exit

2.12

Configure SFP+ ports for LAG

These commands assign four 10Gb SFP+ ports to the Port Channel.

console(conf)#interface range Tengigabitethernet 1/0/21-24

console(conf-if)#channel-group 1 mode active

console(conf-if)#exit

console(conf)#exit

2.13

Save configuration

console#copy running-config startup-config

This operation may take a few minutes.

Management interfaces will not be available during this time.

Are you sure you want to save? (y/n)y

2.14

Configure additional switch

Repeat the commands from section 2 to configure the second switch.

Note: The preceding procedure places all switch ports in the default VLAN. If you prefer to place ports in a

non-default VLAN, refer to the documentation for your switch.

SCG1008

PowerConnect 8024, 8024F, M8024 and M8024-k Switch Configuration Guide for EqualLogic SANs