Dell PowerConnect M8024-k Panduan Konfigurasi - Halaman 9
Jelajahi secara online atau unduh pdf Panduan Konfigurasi untuk Beralih Dell PowerConnect M8024-k. Dell PowerConnect M8024-k 21 halaman. Upgrading from version 2.x.x.x or 3.x.x.x or 4.x.x.x or 5.x.x.x to 5.1.9.3 firmware
Juga untuk Dell PowerConnect M8024-k: Catatan Rilis (27 halaman), Meningkatkan Firmware (24 halaman)
Halaman Cetak
2.11
Configure port channel for LAG
These commands configure the switch interconnect as a LAG.
console(conf)#interface Port-channel 1
console(conf-if-Po1)#mtu 9216
console(conf-if-Po1)#exit
2.12
Configure SFP+ ports for LAG
These commands assign four 10Gb SFP+ ports to the Port Channel.
console(conf)#interface range Tengigabitethernet 1/0/21-24
console(conf-if)#channel-group 1 mode active
console(conf-if)#exit
console(conf)#exit
2.13
Save configuration
console#copy running-config startup-config
This operation may take a few minutes.
Management interfaces will not be available during this time.
Are you sure you want to save? (y/n)y
2.14
Configure additional switch
Repeat the commands from section 2 to configure the second switch.
Note: The preceding procedure places all switch ports in the default VLAN. If you prefer to place ports in a
non-default VLAN, refer to the documentation for your switch.
9
SCG1008
PowerConnect 8024, 8024F, M8024 and M8024-k Switch Configuration Guide for EqualLogic SANs