- ページ 13

スイッチ Dell PowerConnect W-650のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Dell PowerConnect W-650 20 ページ。 Dell networking w-600 controller series
Dell PowerConnect W-650 にも：補足マニュアル (42 ページ), 仕様 (2 ページ)

ページを印刷する

Pre-Installation Requirements

The following tools and equipment are required for installation of a W-650 Series controller.

Rack Mount Bracket (x2, not used for tabletop installation)

Suitable Screwdrivers

AC Power Cord (country-specific)

Left and right side bezels (not used for rack mounting)

Caution: Installation and service of Dell Networks products should be performed by Professional Installers. Additional antenna

and transmit power information for Professional Installers can be found at https://support.dell.com.

For a Telecom Rack:

M3, 6mm x 0.5mm Phillips Head Screws (6x, included)

12-24 x 5/8" Phillips Head Screws (4x, included)

For a Server Rack:

M3, 6mm x 0.5mm Phillips Head Screws (6x, included)

M6 x 20mm Phillips Head Screws (4x, included)

M6 Cage Nuts (4x, included) or M6 Cage Clips (4x, included)

Installation in a Telecom Rack

To install a W-650 Series controller into a 19-inch (48.26 cm) Telecom rack system:

1. Place a rack mount bracket over the mounting holes on one side of the controller (see

2. Secure the bracket to the controller using three M3, 6mm x 0.5mm phillips head screws and a screwdriver.

3. Repeat these steps on the opposite side of the controller.

Dell PowerConnect W-650 Controller | Installation Guide

Chapter 2

W-650 Series Installation

Figure

W-650 Series Installation |

6).