- ページ 16

スイッチ Dell PowerEdge M420のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Dell PowerEdge M420 25 ページ。 Dell poweredge blade servers getting started guide
Dell PowerEdge M420 にも: 情報更新 (38 ページ), リリースノート (27 ページ), ユーザーマニュアル (23 ページ), 重要事項説明書 (35 ページ), 更新マニュアル (32 ページ), 更新マニュアル (28 ページ), ユーザーマニュアル (26 ページ), ユーザーマニュアル (22 ページ), スタートマニュアル (12 ページ), マニュアル (38 ページ), テクニカル・マニュアル (46 ページ), テクニカル・マニュアル (48 ページ), ポートフォリオ・マニュアル (27 ページ), スタートマニュアル (14 ページ), スタートマニュアル (12 ページ)

Dell PowerEdge M420 マニュアル
Rev 1.00
Description:
Use this command to restart the module components. When this command is issued, PTM compo-
nents go through a full hardware reset, followed by software reload.
Options:
• device_number: specify a single device to reset
Example:
$ reload
3.5

Software Update Commands

3.5.1 show image ver

Synopsys:
show image ver
Description:
Display the current software image version.
ADMIN: This command also displays the firmware version of each component.
Example:
# login admin
& show image ver
Software image short version: V Z.ZZ
Software image version: X.X.XXX-<date stamp>
Component #1 firmware version: Y.Y.YYY
Component #2 firmware version: Y.Y.YYY
Component #3 firmware version: Y.Y.YYY
& login user

3.5.2 copy image from-file

Synopsys:
copy image from-file [device_number]
Description:
Update the firmware the PTM software image. In ADMIN mode, it allows selective upgrade of a
single device in the PTM. Immediately after running this command, the CLI waits for the user to
send the firmware image using the ZModem protocol. To abort this operation, use CTRL-C. For
additional details on the firmware update procedure refer to
on page 22
.
ADMIN:
16
Section 4, "Operating Procedures,"
Software User's Manual