- ページ 20

洗濯機 Miele PG 8581のPDF 補足文書をオンラインで閲覧またはダウンロードできます。Miele PG 8581 40 ページ。 Washer disinfector

Miele PG 8581 補足文書

6.4. Advisory Codes (cycle interrupts)

You can correct for many of the advisory codes designed to protect your washer disinfector. The advisory codes listed below
can be cleared
In the event of a cycle being interrupted, an advisory code is displayed e.g. Fault XXX, (where XXX represents a number):
1.
Switch the machine off using the
2.
Wait approximately 10 seconds before switching the machine on again with the
3.
Acknowledge the advisory code by entering your lock code.
4.
Correct any issue.
5.
Start the previously selected cycle again.
If the same message appears again:
1.
Make a note of the advisory code.
2.
Switch the machine off using the
3.
Review the information below:
Please also read the notes regarding the following advisory codes:
Advisory code
Fault 403-405
Fault 406-408
Fault 412-414
Fault 432
Fault 433
20
button.
button.
Cause and remedy
A programme has been cancelled because water intake by the machine was insufficient or
severely restricted.
Open the stopcocks fully
Follow the further information given in the Check water inlet message in the Miele Operating
Instructions.
A programme was cancelled because the water intake volume is insufficient.
Check whether the stopcocks are fully opened.
Contact Eschmann for advice.
A programme was cancelled because the water intake volume is too high.
Contact Eschmann for advice.
The door was opened using the emergency release.
See 'Opening the door using the emergency release'.
Protruding wash load items are preventing the door from being closed properly by the
Comfort lock.
Arrange the wash load so that it does not obstruct the door.
Close the door.
button.
MUW216743-2