- ページ 21

洗濯機 Miele PG 8581のPDF 補足文書をオンラインで閲覧またはダウンロードできます。Miele PG 8581 40 ページ。 Washer disinfector

Advisory code

Fault 440

Spray arms:

Fault 460 - top

Fault 461 - middle

Fault 462 - bottom

Fault 518 (For DOS1)

Fault 519 (For DOS3)

Fault 526

MUW216743-2

Cause and remedy

The float switch in the sump of the machine has not been activated. The switch may be

blocked.

Remove the filter combination.

Check the float switch to make sure it moves freely. The float switch is located in the sump of

the machine behind the spray arm

The programme has been cancelled because of a blocked spray arm.

Arrange the load so that the spray arms can turn easily.

Clean cabinet and filters if dirty and gritty. Abrasive pastes should not be processed in this

machine.

Foaming can cause these Advisory codes. Check that instruments have been rinsed before

loading into the washer disinfector. Chemical residues may cause foaming. To clean foam

from the washer disinfector, remove the majority using a container and then run one or

more rinse cycles.

No flow was detected when dispensing from an external supply container.

For all chemicals, the safety instructions given in the manufacturer's safety

Check the level of the container and refill or replace it as necessary.

Check the suction apertures of the siphons and remove any deposits.

Check the hose connections on the siphons, the machine and any DOS modules.

Remove any kinks from the dispensing hoses and check the hoses for leaks. Position the

dispensing hoses so they cannot kink.

Vent the dispensing system.

If you identify any leaks in the dispensing hoses or defects on the siphons, contact Eschmann.

Minimum flow pressure was not reached because one or more free water connections in the

back panel of the wash cabinet is not properly secured.

Check the washers in the water connectors in the back panel of the wash cabinet and

remove any blockages.

Foaming can cause this Advisory code. Check that instruments have been rinsed before

loading into the washer disinfector. Chemical residues may cause foaming. To clean foam

from the washer disinfector, remove the majority using a container and then run one or

more rinse cycles.

- CAUTION

Handling of chemicals

data must be observed.