- ページ 4

コントロールユニット Allmatic BIOS1のPDF 設置マニュアルをオンラインで閲覧またはダウンロードできます。Allmatic BIOS1 12 ページ。 Battery charging kit
Allmatic BIOS1 にも：インストール (2 ページ)

ページを印刷する

4. Remote control learning

4.1 Learning of one transmitter

The 1st memorized button performs the STEP by STEP function (opening and closing of the gate), the 2

button performs the OPEN function, 4

The control unit exits from the learning phase if no new button or trasnmitter command is given in 10 seconds.

Make sure that the board is out of any

menus, press the button UP[+]

Press one button of the transmitter

If you want to memorize another button or a new

transmitter repeat the procedure

4.2 Learning with the hidden button of an already memorized transmitter

With the hidden button of a transmitter it is possible to enter the learning phase in order to memorize new buttons or new transmitters.

With the automation still, with the aid of a clip press the hidden button of an already memorized transmitter, the flashing light lights on, now it is

possible to memorize new buttons or transmitters.

4.3 Cancellation of one transmitter

Enter the learning phase with the UP[+] button or with the hidden button of a memorized transmitter (see 4.1 or 4.2).

Press in the same time the hidden button and 1

The flashing light bilnks 4 times and on the display will appear

5. Setting stroke

5.1 Easy settings of the stroke (parameter LsI

Be sure that the limit switches are connected and correctly adjusted

Unlock the gate and move it to the middle of the stroke

Press and keep pressed the buttons UP[+] e MENU

for at least 5 seconds.

When the gate reaches the opening limit switch it

stops by itself

When the gate reaches the closing limit switch it stops

by itself

When the gate reaches the opening limit switch it

stops by itself

Warning: in case of intervention of a safety device, the learning is stopped and will appear on the display the written

Press Step by Step button to start again the learning from the 2

6-1622241

rev.6

04/12/2018

button performs the CLOSE function.

button of the transmitter that you want to cancel.

LsI ≠ P P P P )

LsI

point.

ITA

ENG

On the display will appear

and the flashing light lights on

On the display will appear don

If the transmitter was already

memorized will appear Fnd

After 2 seconds the display will show the

memory location of the memorized transmitter,

for example

The gate moves in opening.

If the gate moves in closing press the button

DOWN to stop and reverse the direction of

movement and give a step by step command

(SS) to resume the procedure

The gate moves in closing

The gate moves in opening

The gate closes with the settings of slowing

down set in the menu. When the gate is closed

the learning phase is ended.

FRA

ESP

DEU

POR

button performs the partial opening, the 3

don.

don

Fnd.

Fnd

4 / 12