- ページ 15

ゲートオープナー Allmatic HYPER 400のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Allmatic HYPER 400 16 ページ。 Ambidextrous irreversible operator for swing door gates

6.6 CONNECTION TO THE CONTROL UNIT

Make connections to the control unit only in the absence of power supply.

For the 230Vac and 120Vac gearmotors, install the capacitor supplied between Phase 1 and Phase 2 of the motor.

Please refer to the installation manual of the control unit for the connection diagram.

TABLE 9 - Cable colour for 230Vac motor

COLOUR

Black

Brown

Grey or Blue

Yellow / Green

7. DECLARATION OF CONFORMITY

Manufacturer: Allmatic srl

Address: Via dell'Artigiano, 1 - 32026 Borgo Valbelluna (BL) Italia

Telephone: +39 0437 751175

Web site: www.allmatic.com

Declares that the HYPER product complies with the provisions of Community Directives:

2014/35/EU - Low Voltage Directive

2014/30/EU - Electromagnetic Compatibility Directive

This product cannot work independently and is designed to be integrated into a system with other devices. It is complies with Article

6, paragraph 2, of Directive 2006/42/EC (Machinery) and subsequent amendments, therefore the device cannot be put into opera-

tion before it has not been declared compliant in the total context of use in accordance with the provisions of directive.

This statement is given in a shorter form for graphic reasons.

The full version is available by contacting the manufacturer.

For the correct maintenance of the automation, make sure to perform at least once every 6 months the following steps:

Check that all the fixing screws of the brackets are tight.

Check that the gate is in good condition and that there are no broken or worn parts.

Check the status of the electrical connections and in case of wear of the cables replace them.

Unlock the motor and move the gate manually by checking that the movement is fluid. In case it is necessary to

put a layer of lubricating grease on the stem.

6-1624982 - rev.1 - 20/05/2021

DESCRIPTION

Phase 1

Phase 2

Neutral

Ground

CAPACITOR

GROUND

ENG

PHASE 1

PHASE 2

CONTROL UNIT

NEUTRAL

15 / 16