Diagnostics menu
Select
Hard Drive Self-Test options
Memory Check
Startup Check (select models only)
System Configuration menu
NOTE:
computer.
Select
Language (or press f2)
Boot options
Device configurations
6
Chapter 3 Computer Setup menus
Some of the listed System Configuration options may not be supported by your
To do this
Run a comprehensive self-test on any hard drive in the system
or on any optional MultiBay hard drive.
Run a comprehensive check on system memory.
Verify the system components needed for starting the
computer.
To do this
Change the Computer Setup language.
●
Set f9, f10, and
f12
delay when starting up.
●
Enable/disable CD-ROM boot.
●
Enable/disable floppy boot.
●
Enable/disable internal network adapter boot and set the
boot mode (PXE or RPL).
●
Enable/disable MultiBoot, which sets a boot order that
can include most boot devices in the system.
●
Set the Express Boot Popup delay in seconds.
●
Set the boot order.
●
Swap the functions of the
●
Enable/disable multiple standard pointing devices at
startup. (To set the computer to support only a single,
usually nonstandard, pointing device at startup, select
Disable.)
●
Enable/disable USB legacy support. When enabled, USB
legacy support allows the following:
●
Use of a USB keyboard, mouse, and hub in
Computer Setup even when a Windows operating
system is not running.
●
Startup from bootable USB devices, including a hard
drive, diskette drive, or optical drive connected by a
USB port to the computer or to an optional docking
device (select models only).
●
Select a parallel port mode: EPP (Enhanced Parallel
Port), standard, bidirectional, or ECP (Enhanced
Capabilities Port).
●
Enable/disable BIOS DMA data transfers.
fn
key and left
ctrl
key.
ENWW
ページを印刷する