- ページ 28
クックトップ Miele CS 1212のPDF 操作およびインストール手順をオンラインで閲覧またはダウンロードできます。Miele CS 1212 48 ページ。 Ceramic cooktops with induction
Miele CS 1212 にも： 操作およびインストール手順 (48 ページ), 取付説明書 (21 ページ)
ページを印刷する
Problem solving guide
,
Installation work and repairs to
electrical appliances must only be
carried out by a suitably qualified
and competent person in strict
accordance with current local and
national safety regulations. Repairs
and other work by unqualified
persons could be dangerous. The
manufacturer cannot be held liable
for unauthorised work.
What to do if ...
... the cooking zones do not heat up.
Check whether
– the safety lock is activated.
If necessary, deactivate it (see
"Safety lock").
– the mains fuse has tripped.
– the overheating protection
mechanism has been triggered (see
section "Protection from
overheating").
– the demo mode has been activated.
When demo mode has been
activated, the "d" symbol will appear
in the display for a second.
To deactivate demo mode, turn the
control anticlockwise as far as it will
go twice briefly (<1 second), then
turn it again and hold for approx. 3
seconds.
28
If none of the above is the case, then
turn the control to "0", and disconnect
the appliance from the electricity
supply for approx. 1 minute.
Reset the trip switch in the mains fuse
box, and switch the appliance back on.
If it still will not switch on, contact a
qualified electrician or the Miele
Customer Contact Centre.
... an ß appears in the display for a
cooking zone.
Check whether
– the zone was switched on by mistake
without a pan on it.
– the pan being used is suitable for
use on an induction zone, and that it
is large enough (see "Pans").
... an F appears in the display for a
cooking zone.
The temperature sensor for that
cooking zone is defective.
Do not use this zone until it has been
repaired.
Contact your nearest Service Dept.
(See back page for address).
... one or more cooking zones has
switched itself off automatically.
The safety switch-off feature or the
overheating protection mechanism has
been triggered (see "Safety switch-off"
and "Overheating protection").