- ページ 2

浄水器 AllPondSolutions 500-HO+のPDF マニュアルをオンラインで閲覧またはダウンロードできます。AllPondSolutions 500-HO+ 17 ページ。 Aquarium hang-on filter with uv

To ensure your new hang on ﬁlter is set up and running correctly, and to prevent

any accidental damage or injury, please read and follow the below instructions

carefully before using your product.

SAFETY

Important!

Disconnect the mains electricity supply before attempting any

installation / maintenance of any kind. Do not attempt to modify this unit in

any way and only use the recommended parts for replacement.

The hang on ﬁlter should never be run dry as this will cause the unit to

overheat and cause permanent damage.

All connections must be earthed.

The power cord of this appliance cannot be replaced; if the cord is

damaged, the appliance should be discarded. Never cut the cord.

Do not connect to any voltage other than that stated.

This ﬁlter is suitable for indoor household aquariums only (do not use in

exterior locations, swimming pools, ponds, bathrooms etc). Do not place in

liquids other than water.

Do not use with water above 90F or 30C.

Do not carry or pull the unit by its electrical cable.

Do not use this unit if it has a damaged cord or plug, if it is malfunctioning

or it is dropped or damaged in any manner

Do not yank cord to pull plug from outlet. Grasp the plug and pull to

disconnect. Always unplug an appliance from an outlet when not in use.

Do not attempt to modify this unit in any way and only use the

recommended parts for replacement.

Before installing, maintaining or handling your equipment, or before placing

your hands in your aquarium, ensure that the unit is disconnected from the

electricity supply.

Always unplug any electrical devices when not in use.

Carefully examine your ﬁlter after installation. Do not plug in the unit to the

mains if there is water on any parts not intended to be wet.