- ページ 13
溶接システム Miller Cool Runner 3CSのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Miller Cool Runner 3CS 20 ページ。
Miller Cool Runner 3CS にも： オーナーズマニュアル (24 ページ)
ページを印刷する
SECTION 7 − MAINTENANCE & TROUBLESHOOTING
7-1. Routine Maintenance
n = Check
* To be done by Factory Authorized Service Agent
Every
~Clean coolant strainer. Severe
3
conditions may require more frequent
Months
cleaning (continuous use, high/low
temperatures, dirty environment,
etc.). Failure to properly clean coolant
strainer voids pump warranty.
Every
6
Months
nlHoses
Every
12
Months
ZChange coolant (if using Miller coolant).
7-2. Coolant Maintenance
Z = Change
~ = Clean
nl Labels
1
= Repair
~ Blow out heat exchanger fins.
nCheck coolant level.
ZChange coolant if using water.
805 516-A
l = Replace
!
Disconnect cooler plug from
welding power source re-
ceptacle before maintaining.
1
Coolant Filter
Unscrew housing to clean filter.
Changing coolant: Drain coolant by
tipping unit forward. Fill with clean
water and run for 10 minutes. Drain
and refill.
.
If replacing hoses, use hoses
compatible with ethylene gly-
col, such as Buna-n, Neo-
prene, or Hypalon. Oxy-acety-
lene hoses are not compatible
with any product containing
ethylene glycol.
OM-230 161 Page 9