Miller Cool Runner 3CS Посібник користувача - Сторінка 13
Переглянути онлайн або завантажити pdf Посібник користувача для Зварювальна система Miller Cool Runner 3CS. Miller Cool Runner 3CS 20 сторінок.
Також для Miller Cool Runner 3CS: Посібник користувача (24 сторінок)
Друкувати сторінку
SECTION 7 − MAINTENANCE & TROUBLESHOOTING
7-1. Routine Maintenance
n = Check
* To be done by Factory Authorized Service Agent
Every
~Clean coolant strainer. Severe
3
conditions may require more frequent
Months
cleaning (continuous use, high/low
temperatures, dirty environment,
etc.). Failure to properly clean coolant
strainer voids pump warranty.
Every
6
Months
nlHoses
Every
12
Months
ZChange coolant (if using Miller coolant).
7-2. Coolant Maintenance
Z = Change
~ = Clean
nl Labels
1
= Repair
~ Blow out heat exchanger fins.
nCheck coolant level.
ZChange coolant if using water.
805 516-A
l = Replace
!
Disconnect cooler plug from
welding power source re-
ceptacle before maintaining.
1
Coolant Filter
Unscrew housing to clean filter.
Changing coolant: Drain coolant by
tipping unit forward. Fill with clean
water and run for 10 minutes. Drain
and refill.
.
If replacing hoses, use hoses
compatible with ethylene gly-
col, such as Buna-n, Neo-
prene, or Hypalon. Oxy-acety-
lene hoses are not compatible
with any product containing
ethylene glycol.
OM-230 161 Page 9