- ページ 30
溶接システム Miller FieldPro Feeder CEのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Miller FieldPro Feeder CE 44 ページ。 With weld cable control
ページを印刷する
SECTION 7 − MAINTENANCE & TROUBLESHOOTING
7-1. Routine Maintenance
n = Check
* To be done by Factory Authorized Service Agent
Every
3
Months
l Damaged Or Unreadable Labels
n l Cracked Cables And Cords
Every
6
Months
n ~ Drive Rolls
7-2. Overload Protection And Thermostat Protection
Internal Side View
OM-267043 Page 24
Z = Change
~ = Clean
!
Disconnect power
before maintaining.
l = Replace
l Damaged Gas Hose
~ Blow Out Or Vacuum Inside
1
CB1
.
Maintain more often
during severe conditions.
!
Turn Off wire feeder and
welding power source. Stop
engine on welding
generator.
1
Supplementary Protector CB1
CB1 protects wire feeder from over-
load. Correct problem and reset
CB1.
Close and latch door.
Thermostat Protection
Unit has internal thermostat protec-
tion and will not feed wire if over-
heating occurs (see Section 7-4).
Ref. 257 794-B