Miller FieldPro Feeder CE Manual do Proprietário - Página 30
Procurar online ou descarregar pdf Manual do Proprietário para Sistema de soldadura Miller FieldPro Feeder CE. Miller FieldPro Feeder CE 44 páginas. With weld cable control
Imprimir página
SECTION 7 − MAINTENANCE & TROUBLESHOOTING
7-1. Routine Maintenance
n = Check
* To be done by Factory Authorized Service Agent
Every
3
Months
l Damaged Or Unreadable Labels
n l Cracked Cables And Cords
Every
6
Months
n ~ Drive Rolls
7-2. Overload Protection And Thermostat Protection
Internal Side View
OM-267043 Page 24
Z = Change
~ = Clean
!
Disconnect power
before maintaining.
l = Replace
l Damaged Gas Hose
~ Blow Out Or Vacuum Inside
1
CB1
.
Maintain more often
during severe conditions.
!
Turn Off wire feeder and
welding power source. Stop
engine on welding
generator.
1
Supplementary Protector CB1
CB1 protects wire feeder from over-
load. Correct problem and reset
CB1.
Close and latch door.
Thermostat Protection
Unit has internal thermostat protec-
tion and will not feed wire if over-
heating occurs (see Section 7-4).
Ref. 257 794-B