- ページ 9

溶接システム Miller XR-W AlumaPro Plus 25 ftのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Miller XR-W AlumaPro Plus 25 ft 36 ページ。 Ce and non-ce models air and water-cooled guns; 250 ampere (air) push-pull; 300 ampere (air) push-pull; 400 ampere (water) push-pull

Miller XR-W AlumaPro Plus 25 ft オーナーズマニュアル

3-1. Additional Safety Symbols And Definitions

.
Some symbols are found only on CE products.
Warning! Watch Out! There are possible hazards as shown by the symbols.
Do not discard product (where applicable) with general waste.
Reuse or recycle Waste Electrical and Electronic Equipment (WEEE) by disposing at a designated collection
facility.
Contact your local recycling office or your local distributor for further information.

3-2. Miscellaneous Symbols And Definitions

A
Amperes
V
Volts
Alternating Cur-
rent
X
Duty Cycle
Wire Feed
Gun
Trigger Hold Off
Run-In
Read Instructions
Water (Coolant)
Input
SECTION 3 − DEFINITIONS
U
2
Hz
Circuit Breaker
U
Trigger
Trigger Hold On
Percent
IP
Load Voltage
Line Connection
Continuous
Spot Welding
Hertz
Output
Increase
Safe1 2012−05
Safe37 2017−04
Spot Weld Time
Primary Voltage
1
I
Rated Current
2
Fuse
Degree Of
Protection
Jog
Press To Set
Purge
Burnback Time
I
Primary Current
1
Water (Coolant)
Output
OM-245892 Page 5