- ページ 17

溶接システム Miller XT30のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Miller XT30 44 ページ。 Air plasma cutting and gouging
Miller XT30 にも：オーナーズマニュアル (40 ページ)

B. Torch

The XT30 torch is intended for handheld use only. The torch conforms to IEC 60974-7 when used with the Spectrum 375 X-TREME.

Do not use this torch in combination with any other machines.

Gas Type

Gas Quality

Gas Inlet Flow And Pressure

Gas Filtering

Mild Steel Capacities — See Section 6-2 for cutting speeds vs material type and thickness.

Cooling Method

Duty Cycle Of Torch

Rating Of Electrical Controls (Trigger)

Rating of Electrical Controls (Cup)

Approved Systems

Trigger Protection

Safety Devices

Rated Capacity (Edge Start)

Sever Cut Capacity (Edge Start)

Pierce Capacity

Weight

*Travel Speeds Are Approximately 80% Of Maximum.

Requirements For The Torch Connection:

� Use only compressed air which is free from dirt, oil, and water.

� Ensure that the connections are properly assigned and tightened.

� For torch replacement, see Miller torch manual Part No. OM-254449

� Ensure correct air pressure (flow pressure) and airflow (volume) are set. Insufficient airflow can lead to the torch overheating.

�

Complete Parts List is available at www.MillerWelds.com

Air

Clean, Moisture-Free, Oil-Free

5.0 SCFM (142 L/min)

90 psi (621 kPa) Min

120 psi (827 kPa) Max

Particulates To 5 Microns

Air

100% At 30 Amps

30 VDC At 0.1 Amps

30 VDC At 1 Amp

Spectrum 375 X-TREME w/XT30 torch

Safety Trigger Guard

Safety Interlock Devices Shut Down Power Source

3/8 in. At 18 ipm (457 mm/min)*

5/8 in.

3/16 in.

2.2 lb (1 kg)

OM-253555 Page 13