Miller XT30 Kullanıcı El Kitabı - Sayfa 17

Kaynak Sistemi Miller XT30 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Miller XT30 44 sayfaları. Air plasma cutting and gouging
Ayrıca Miller XT30 için: Kullanıcı El Kitabı (40 sayfalar)

Sayfayı Yazdır
Miller XT30 Kullanıcı El Kitabı
B. Torch
The XT30 torch is intended for handheld use only. The torch conforms to IEC 60974-7 when used with the Spectrum 375 X-TREME.
Do not use this torch in combination with any other machines.
Gas Type
Gas Quality
Gas Inlet Flow And Pressure
Gas Filtering
Mild Steel Capacities — See Section 6-2 for cutting speeds vs material type and thickness.
Cooling Method
Duty Cycle Of Torch
Rating Of Electrical Controls (Trigger)
Rating of Electrical Controls (Cup)
Approved Systems
Trigger Protection
Safety Devices
Rated Capacity (Edge Start)
Sever Cut Capacity (Edge Start)
Pierce Capacity
Weight
*Travel Speeds Are Approximately 80% Of Maximum.
Requirements For The Torch Connection:
� Use only compressed air which is free from dirt, oil, and water.
� Ensure that the connections are properly assigned and tightened.
� For torch replacement, see Miller torch manual Part No. OM-254449
� Ensure correct air pressure (flow pressure) and airflow (volume) are set. Insufficient airflow can lead to the torch overheating.
�
Complete Parts List is available at www.MillerWelds.com
Air
Clean, Moisture-Free, Oil-Free
5.0 SCFM (142 L/min)
90 psi (621 kPa) Min
120 psi (827 kPa) Max
Particulates To 5 Microns
Air
100% At 30 Amps
30 VDC At 0.1 Amps
30 VDC At 1 Amp
Spectrum 375 X-TREME w/XT30 torch
Safety Trigger Guard
Safety Interlock Devices Shut Down Power Source
3/8 in. At 18 ipm (457 mm/min)*
5/8 in.
3/16 in.
2.2 lb (1 kg)
OM-253555 Page 13