- ページ 13

溶接アクセサリー Miller 261970のPDF オリジナル取扱説明書をオンラインで閲覧またはダウンロードできます。Miller 261970 40 ページ。 Integrated headgear cooling system

SECTION 3 − HEADGEAR COOLING SYSTEM

Read and follow these instructions and the safety labels carefully. This

product is intended for use as a cooling device only. It is not a respiratory pro-

tective device and does not protect the user from airborne contaminants. Have

an industrial hygienist test the air in your facility to determine if respiratory

protection is required to provide adequate protection from contaminants in

your environment. With cooling system-equipped helmet on your head and

cooling system operating, also test the air inside the helmet to determine if

respiratory protection is required. If you have questions about the type of res-

piratory protection equipment required, consult your safety director and an

Industrial Hygienist.

Use the cooling system only with compatible Miller welding helmets (MP-10t,

Pro-Hobbyt, Performancet, Elitet, Titaniumt series helmets). See the welding

helmet Owner's Manual for information on helmet operation.

The CoolBandt headgear cooling system draws in air and blows it to the front of the weld-

ing helmet through a flexible tube. The system also generates a positive air pressure to

help prevent contaminants from entering the helmet. The system must include and/or be

used with the equipment listed below:

Helmet and cowl (head shroud)

Blower assembly with properly-installed filter

Battery charger

The headgear cooling system operates at temperatures from 14° ⎫↵ 131° F (−10° to 55°

C). The Battery Level red light flashes and blower assembly pulses on and off when bat-

tery power is low.

OM-262 902 Page 10