Miller 261970 Original Instructions Manual - Page 13

Browse online or download pdf Original Instructions Manual for Welding Accessories Miller 261970. Miller 261970 40 pages. Integrated headgear cooling system

Miller 261970 Original Instructions Manual
SECTION 3 − HEADGEAR COOLING SYSTEM
Read and follow these instructions and the safety labels carefully. This
product is intended for use as a cooling device only. It is not a respiratory pro-
tective device and does not protect the user from airborne contaminants. Have
an industrial hygienist test the air in your facility to determine if respiratory
protection is required to provide adequate protection from contaminants in
your environment. With cooling system-equipped helmet on your head and
cooling system operating, also test the air inside the helmet to determine if
respiratory protection is required. If you have questions about the type of res-
piratory protection equipment required, consult your safety director and an
Industrial Hygienist.
.
Use the cooling system only with compatible Miller welding helmets (MP-10t,
Pro-Hobbyt, Performancet, Elitet, Titaniumt series helmets). See the welding
helmet Owner's Manual for information on helmet operation.
The CoolBandt headgear cooling system draws in air and blows it to the front of the weld-
ing helmet through a flexible tube. The system also generates a positive air pressure to
help prevent contaminants from entering the helmet. The system must include and/or be
used with the equipment listed below:
D
Helmet and cowl (head shroud)
D
Blower assembly with properly-installed filter
D
Battery charger
The headgear cooling system operates at temperatures from 14° ⎫↵ 131° F (−10° to 55°
C). The Battery Level red light flashes and blower assembly pulses on and off when bat-
tery power is low.
OM-262 902 Page 10